Tabla de contenido
Publicidad
HOOD
fig. 56
Insert the ends of the hood in the proper seats on
the sides of the transport seat and hook the buttons to the
structure.
fig. 57
The hood covering can be removed to allow its correct
maintenance.
fig. 58
Unhook the buttons (H1) positioned on both sides
fig. 59
rods (H3
fig. 60
To reassemble the covering, insert both rods (H3) in
the proper guides on the internal lining.
fig. 61
Then, insert the rods (H3) in the proper seats
hooked.
fig. 62
WARNING: the curved insertion part of the
articulated joints (H2) must always be positioned on the
front.
MUFF
fig. 63
Position the muff (R3) letting it pass under the
bumper bar.
fig. 64
Secure the central string (A1
the ring (A2).
fig. 65
Fasten the 2 lower buttons (A3) to the
corresponding studs beneath the stroller platform.
fig. 66
Secure the 2 side strings (A4) around the handrail
fig. 67
The muff can be wrapped around itself when
hooking the central string (A1) to the corresponding lower
A5).
fig. 68
position for protecting the child against cold weather.
fig. 69
The muff can be used either on the transport seat
facing the mum or street.
ADJUSTMENT OF THE FOOTREST PLATFORM
fig. 70
To lower the platform act on both levers (S5)
press it downwards.
fig. 71
SAFETY BELTS
fig. 72
fig. 73
the ends of the waist one.
fig. 74
Fasten the ends of the waist belt to the central
buckle.
fig. 75
rings (S6
fig. 76
WARNING! The inobservance of this precaution may
result in the falling or sliding out of the baby with a
resulting risk of injury.
MAINTENANCE OF THE LINING
provide for its correct maintenance.
fig. 77
INSTRUCTIONS
H2).
H2) from the
H2
fig. 78
unhook all buttons of the lining.
fig. 79
Then, pass the back straps through the buttonholes
on the lining.
fig. 80
Remove the crotch strap and then the entire lining.
platform (S7
under the lining of the same.
WARNING: make sure that the lining has been properly
reassembled before use.
RAIN COVER (IF AVAILABLE)
fig. 81
To mount rain cover (R4), place it on the hood and
button up the snap fastners on the side (P1).
fig. 82
Then, pass the two rubber bands (P2) around the
hooks (P3) under the front platform.
S6)
S7) and
31
Publicidad
Tabla de contenido
