Connecting The Dvr - Sanyo VA-EXH Manual De Instrucciones

e00_l8hcb_xe_7.book Page 8 Thursday, March 10, 2005 3:23 PM
1 HARD DISK INSTALLATION AND CONNNECTION TO DVR
If expanding the number of hard disks to three or more,
install the first one to 3
reattach the installation block that was removed in step 2,
and then install the last two hard disks to
[Attaching the installation block]
Insert projection A into hole B by sliding the center of the front
part. Align the positioning points on both sides two at a time
and secure the nine points with screws.
* Insert projection A properly or else the hard disk installation
block cannot be attached correctly.
* Tightening torque: 0.6 N•m - 0.7 N•m (6 - 7 kgf•cm)
Positioning points
7
After installing the hard disk, follow the
procedure shown in step 1 in reverse
order to close the cover.
and the second one to 4 ,
1 2
and .
B
A
Positioning points

Connecting the DVR

Use the following procedures to connect the DVR to the
external storage unit.
1
Use the four external storage unit
cables included with this product to
connect the external storage unit to the
DVR.
External
storage
unit
DVR
Even if there are only one to three hard disks, connect all
four external storage unit cables.
Make sure to connect correspondingly numbered terminals
on the external storage unit and DVR.
2
Use the supplied bracket to secure the
external storage unit cables.
Screws
(supplied)
Use another supplied bracket to secure the cables at the
DVR end as well.
8
Rib
External
storage unit
cable
Rib
1 2 3 4
External
storage unit
connection
terminals
Bracket
(supplied)
English