Fagor VP-30C Manual De Instrucciones página 9

All manuals and user guides at all-guides.com
interior 19/1/06 16:53
Check that the blades do not touch
anything when you turn them by hand.
The blades must turn freely, if not repeat
from step 2.
4. Assemble the front grille (8) and press
gently until it fits into the plastic ring.
5. Close the safety clip by tightening the nut.
Installing the fan on the wall (Fig. 3 and
4)
• The fan should be assembled in the most
accessible place for the plug socket.
• Using the wall bracket as a guide, make
marks for the drill holes. Then insert the
studs and adjust the bracket firmly with
the screws.
• Hang the fan on its bracket.
• The fan should not be installed at a
height under 2.3m.
5. OPERATION INSTRUCTIONS
The fan can be controlled by pressing the
buttons on the control panel or using the
remote control (Fig. 1.2).
Stop button (2.1.): Press this button
to stop the fan.
Start/speed button (2.2.): Press this
button to start the fan. Press this button again
to select the fan speed. The light will indicate
the selected speed. Every time this button is
pressed, the selected speed will vary
according to the following sequence:
low speed (L)
medium speed (M)
high speed (H)
MODE button (2.3.): Press this button
to make the fan work in day mode. The green
light will come on. If the button is pressed
again, the function will change to night mode.
The red light will come on. If the button is
pressed for a third time, this function will be
deactivated. The sequence is as follows:
Página 7
With this mode, the fan operates by
changing the speed rhythmically, moving from
one speed to another every 15~20 seconds
approximately, stopping for a few seconds
every time a cycle finishes.
With this function, the fan will operate
differently depending on the chosen speed. At
the end of each sequence the fan continues to
operate at low speed, independently of the
initial speed selected.
• High speed sequence:
30 min.
• Medium speed sequence:
30 min.
• Low speed sequence:
Swing button (2.4.): Press this button
to make the fan swing horizontally. Press it
again to deactivate this function.
Timer button (2.5.): Press this button
when you wish to select an operation period
of 1, 2, 4 or 8 hours. The light will indicate the
selected time period. The light will go out
when this function is deactivated. Each time
this button is pressed, it moves from one
selection to another in the following
sequence:
1h
The tilt of the fan can be adjusted according
to Fig. 5
8
Disconnected
30 min.
2h 4h 8h Disconnected
6. TILT