Kohler K-728 Guía De Instalación Rápida página 5

E-Ring
Missing Tooth
Plaster Guard
Mixed Water Supply 3/4"
Copper Tubing or Piping
4. Two-Way Valve Installation
Two Outlet Installations
IMPORTANT! Do not install a 1/2" NPT plug in the unused outlet
without completing the two-way conversion. This valve is not a
shut-off valve.
Two-Way Conversion
Temporarily remove the plaster guard.
Rotate the detent until positioned vertically; see above
illustration.
Verify the missing tooth is oriented up.
IMPORTANT! If the internal plug is not removed as instructed, the
finished wall will need to be removed to perform this step at a later
date.
Identify the internal plug at the center of the valve body and the
spacer underneath the detent.
Using a hex wrench, remove and discard the internal plug.
Plug the port that will not be used (either the left or right port)
with a 1/2" NPT plug (not included).
Use pliers to remove the spacer from beneath the detent.
Push the detent down; ensure the points of the detent engage the
notches of the valve cartridge.
Kohler Co.
Accessory # 2
Water Line
Detent
Spacer
5
Accessory # 1
Water Line
Internal
Plug
1/2"
NPT Plug
1205549-2-B