Maintenance Schedule; Troubleshooting - Ryobi RY09056 Manual Del Operador

THIS PRODUCT WAS MANUFACTURED WITH A CATALYST MUFFLER
Congratulations! You have made an investment toward protecting the environment. In order to maintain this product's
original emission level, please refer to the maintenance section below.
Maintenance
Part
* CATALYTIC MUFFLER ASSEMBLY .......................................................................................................................... X
SPARK SCREEN ........................................................................................................................................................X
* AIR FILTER ASSY
includes:
Filter ..........................................................................................X
* CARBURETOR ASSY
includes:
Gaskets ........................................... X
* FUEL TANK ASSY
includes:
Fuel Lines........................................ X
Fuel Cap ......................................... X
Fuel Filter ..........................................................................................................................X
* IGNITION ASSY
includes:
Spark Plug ........................................................................................................................X
* NOTICE: THE USE OF EMISSION CONTROL COMPONENTS OTHER THAN THOSE DESIGNED FOR THIS UNIT
IS A VIOLATION OF FEDERAL LAW.
PROBLEM
Engine fails to start.
Engine hard to start.
Engine lacks power.
Engine overheats.
If problem persists after trying the above solutions, contact customer service or a qualified service center for assistance.
NOTICE:
As the equipment owner, you are responsible for the performance of the required maintenance listed in the Maintenance section. It
is recommended that you retain all receipts covering maintenance on your equipment. Neglecting or failing to perform the required
maintenance may increase emissions, decrease fuel efficiency, degrade performance, cause irreversible engine damage and/or void
your warranty.
MAINTENANCE

MAINTENANCE SCHEDULE

Inspect for
Damage Before
Each Use

TROUBLESHOOTING

POSSIBLE CAUSE
No fuel in tank.
Spark plug shorted or fouled.
Spark plug is broken. (cracked porcelain
or electrodes broken)
Ignition lead wire shorted, broken, or
disconnected from spark plug.
Ignition inoperative.
Water in gasoline or stale fuel mixture.
Too much lubricant in fuel mixture.
Engine is under or over choked.
Weak spark at spark plug.
Air filter clogged.
Insufficient lubricant in fuel mixture.
12 - English
Clean Replace
Every Every 25 Hours
5 Hours or Yearly
Fill tank.
Replace spark plug.
Replace spark plug.
Replace lead wire or attach to spark plug.
Contact a qualified service center.
Drain entire system and refill with fresh fuel.
Drain and refill with correct mixture.
Adjust choke as necessary.
Contact a qualified service center.
Clean air filter. Refer to Cleaning the Air
Filter earlier in this manual.
Mix fuel as described in starting
instructions.
Replace
Every
50 Hours
SOLUTION