Proper Refrigerator Care And Cleaning; Cleaning And Maintenance; Defrost - Haier HC17SF15RB Manual Del Usuario

English

pROpER REfRiGERATOR cARE AND cLEANiNG

cleaning and maintenance

Warning:
caution:
General:
Door Gaskets:

Defrost

Defrost whenever frost on the wall of the freezer compartment becomes 1/8"
thick.
DANGER - Risk of fire or Explosion due to puncture refrigerant
tubing. flammable refrigerant used. Do not use metal instruments
to defrost refrigerator. Do not puncture refrigerant tubing.
To defrost, remove foods and ice cube tray from the freezer compartment. Make
sure the drip tray is in place and unplug the unit. Defrosting usually takes a few
hours. To defrost faster, keep the door open and place a bowl of warm water in
the refrigerator. After defrosting, empty water from the drip tray and wash the
drip tray in warm water.
maintenance
Risk of Fire or Explosion. Flammable refrigerant used. Do not puncture refrigerant
tubing. To be repaired only by trained authorized service personnel. Consult
Repair Manual before attempting to service this product. All Safety Precautions
Must be followed. Component parts shall be replaced with like components to
minimize the risk of possible ignition due to incorrect parts or improper service.
9
To avoid electric shock, always unplug your
refrigerator before cleaning. Ignoring this warning may result
in death or injury.
Before using cleaning products, always read and follow
manufacturer's instructions and warnings to avoid personal
injury or product damage.
Prepare a cleaning solution of 3-4 tablespoons of baking soda
mixed with warm water. Use sponge or soft cloth, dampened
with the cleaning solution, to wipe down your refrigerator.
• Rinse with clean warm water and dry with a soft cloth.
• Do not use harsh chemicals, abrasives, ammonia, chlorine
bleach, concentrated detergents, solvents or metal scouring
pads. Some of these chemicals may dissolve, damage and/or
discolor your refrigerator.
Clean door gaskets every three months according to general
instructions. Gaskets must be kept clean and pliable to
assure a proper seal.
• Petroleum jelly applied lightly on the hinge side of gaskets
will keep the gasket pliable and ensure a good seal.