Beko CEG5331X Manual Del Usuario página 26

6
Troubleshooting
Problem
No milk foam out from the machine
The hole of Milk tube connector is blocked by
milk residues which hardly to be cleaned
Milk spray out the table
Descaling indicator keep flashing even after
the descaling process
26 / EN
Cause
The hole of Milk tube connector is blocked by
milk residues
The milk tube connector not be cleaned for a
long time
The type of milk used is not suitable for
frothing
The temperature of the milk is too high
Milk dispensing tube is not put in place
Decaling process is not completed
Fully Automatic Coffee Machine / User Manual
Solution
Refer to section "Daily Cleaning of the
appliance" ,follow "cleaning the milk
container and connection milk tube", Clean
the connector and make sure all the hole on
the connector is clean, use needle or bristle of
brush to clean the hole.
Soaking the connection milk tube into warm
water for an hour, follow the "cleaning the
milk container and connection milk tube" in
section "Daily Cleaning of the appliance",
keep using frothing milk function to clean
until water come from dispenser smoothly.
Use needle or bristle of brush to clean the
hole
Different types of milk result in different
amounts of froth and different forth
qualities. Semi-skimmed or full-fat cow's milk
gives good results.
No milk foam out from the machine
Milk foam spray out from dispenser
Please be patient and wait for the process
finish. The machine will auto shut off
automatically , don't switch off the machine
manually