Generis G750 5.80M Platform Assembly - TUBESCA-COMABI GENERIS 750 Instrucciones De Montaje Y De Uso

3-2. GENERIS G750 5.80m platform assembly

1. Assemble the G750 5.80m by carefully repeating steps §3-1 to §3-1-6 but without pre-
mounting the 0.60m extension on to the 1.50m extension.
2. From the ground, remove the 2 temporary guard rails from rung no. 5, and then mount
them definitively on rung no. 7 by following §3-1-7.
3. Remove the temporary platform from rung no. 2, and then mount it definitively on rung
no. 4 by following §3-1-9.
4. Mount the 1
5. Mount the four S1 stabilisers by following §3-1-11.
6. Mount the 2 temporary guard rails on rung no. 10.
7. Assemble the two 1.50m extensions (without the 0.6m extension) by following § 3-1-6.
8. Remove the two temporary guard rails, and then mount them definitively on rung no. 14
by following § 3-1-7.
9. Mount the 3
10.
10. Mount the 2
11. Assemble the two 1.50m + 0.60m extensions (with the 0.60m extension) by following §3-
1-6.
12. Mount the 5
13. Mount the 7
14. Mount the 3
15. Mount the access cradle by following §3-1-12.
16. Check the position of components by following §2-5-2.
17. For heights below the 5.80m platform, lower the guard rails and platforms according to the
required height; if necessary, remove the 1
18. Note that the distance between rungs = 300mm
19. To comply with EN1004-1, the minimum height between platforms must always be 2.10m
and the height of the first platform must be < 3.40m.
106-A000035745 - ind.0 – 11/2021
st nd
and 2 cross braces by following §3-1-8.
rd th th
and 4 , and 5 and 6
nd
permanent platform on rung no.11 by following §3-1-9.
th th
and 6 guard rails on rung no. 21.
th th
and 8 cross braces by following §3-1-10.
rd
and final platform on rung no. 18 by following §3-1-9.
th
cross braces opposite each other by following §3-1-
st
platform along with the 1
st nd
and 2 guard rails.
76