Sauder 418647 Manual Del Usuario página 8

Step 4
Insert the INTERLOCK TRACK (22G) with CABINET
å
ACTUATORS (29G) into the groove in the RIGHT END (A)
exactly as shown.
Fasten two EXTENSION RAILS (N) to each END (A and B).
å
Use eight GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL out to fi nd the other hole
that lines up with the hole in the END. Turn a SCREW into this
hole.
Open end
Page 8
After fastening the RAILS to the ENDS, rest the INTERLOCK
TRACK assembly against the RAILS. There should be no
more than a 1/16" gap between all ACTUATORS and RAILS.
29G
N
B
GOLD 5/16" FLAT HEAD SCREW
22G
N
A
N
418647
Remember:
Righty tighty.
Lefty loosey.
3S
(8 used in this step)
Open end
N
www.sauder.com/services