Orbea BLUE PAPER TERRA OMR 2022 Manual Tecnico página 20

38 | O R BEA
ST E M
OC1 ROAD COMPLETE STEMS
4
GREASE
6 N.m
Always follow the recommended
torque settings.
30 O C1 R OA D ST E M *
ART Nº: X071
Topcap not included
* Available in sizes: 70mm, 80mm, 90mm, 100mm, 110mm,
120mm.
T ECHNI CAL M ANUAL
4
6 N.m
The OC1 road stem uses the profiled OC1
specific topcap and the countersunk bolt
QTY.
that are not included with the stem. They are
1
both included in the OC1 stem hardware kit.
The ICR headset spacers are specific to the
frame the OC1 stem is used on.
B LUE PAP ER T ERR A · O M R 2 0 22
STANDARD STEMS ADAPTER
FOR ICR HEADSETS
The OC HS01 standard stem adapter allows for the instal-
lation of non-OC external cabling stems compatible with
standard round headset spacers on Orbea frames with ICR
headsets.
30
2
The HS01 adapter is only compatible with
ICR headset assemblies that use oval ICR
headset spacers (X063). Orca Aero OMX
2022 is compatible with the use of the HS01
adapter.
GREASE
The HS01 adapter´s cable grommets allow for its use with
all types of drivetrain configurations:
· 2-hole gommets: For mechanical drivetrain assemblies
(2 brake hoses+2 gear outer cables) and electronic driv-
etrain assemblies with wired shifters.
· 1-hole grommets: For wireless Sram Etap and Shimano
12S Di2 (2 brake hoses).
· It is possible to combine the grommets for 1X drive-
train assemblies.
O RB EA | 39 3 9
E N
When installing the HS01 adapter, the neces-
sary headset spacers and the standard stem,
the assembly height may differ from the pre-
vious height with an OC ICR stem.
Check that the distance between the headset
cover and the bottom of the stem does not
exceed the maximum stack height defined in
the bicycle´s technical manual.
Check that the length of the fork´s steerer
tube allows for a secure installation of the
stem and that the cables are long enough.
Never install headset spacers above the
stem. The length of the fork´s steerer tube
must be appropiate so no spacers are need-
ed above the stem.
The stem must be installed onto the fork´s
steerer tube so both stem bolts are over an
area of the steerer tube. Never install the
stem in a position where the top stem bolt is
positioned above the upper limit of the fork´s
steerer tube.