Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the fastening torque
2
3
1
015466
1
015467
When you wish to drive machine screws, wood screws,
hex bolts, etc. with the predetermined torque, adjust the
fastening torque as follows.
1.
First remove the battery cartridge from the tool.
2.
Remove the protector from the clutch case.
3.
Loosen and remove the screw that secures ring.
4.
Rotate the ring on the tool by hand so that a hole
can be seen below the ring.
5.
Place the battery cartridge in place and pull the
switch trigger. Release it so that the adjusting ring
rotates and the hole becomes visible as
illustrated. And then remove the battery cartridge.
1
015468
6.
Use an optional adjusting grip to adjust the fastening
torque. Insert the pin of the adjusting grip into the
hole on the tool. And then, turn the adjusting grip
clockwise to set a greater fastening torque, and
counterclockwise to set a smaller fastening torque.
7.
Align the edge of the adjusting ring with your
desired number on the fastening torque scale.
8.
Insert the battery cartridge and be sure that a fastening
torque has been set up by using a fastening torque tester.
9.
Rotate the ring on the tool and then tighten the
screw to secure the ring.
10. Attach the protector back to the clutch case.
1. Screw
2. Ring
3. Clutch case
1. Scale
2. Hole for
adjusting grip
3. Yellow line
2
3
1. Adjusting grip
NOTE:
Numbers on the fastening torque scale is a
•
guideline to set up your desired fastening torque.
Adjusting no-load speed and revolution angle
Using NFC installed Android-platform device allows no-
load speed and revolution angle adjustment of the tool.
For information about the type of Android-platform
device allowable for this use and how to install and use
application software, please contact a Makita sales
representative.
NOTE:
The N Mark is a trademark or registered trademark of
NFC Formula, Inc. in USA and other countries in the
world.
Android is a registered trademark of Google, Inc.
TM
®
and
are not distinctively indicated on the tool or in
this instruction manual.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Selecting correct socket
There are different types of sockets for some models
depending on applications. Choose and install a correct
socket for your application.
Installing or removing socket
1
2
3
015469
To install the socket, push it onto the square drive of the
tool with one hand by depressing a pin on the square
drive with another hand until it locks into place. To
remove the socket, simply pull it off depressing the pin
on the square drive.
OPERATION
Hold the tool firmly and place the socket over the bolt or
nut. Then switch the tool on. When the clutch cuts in,
the motor will stop automatically. Then release the
switch trigger.
8
1. Socket
2. Hole
3. Pin
Publicidad
Tabla de contenido
