Análisis De Fallos; General - GEA Grasso V Serie Manual De Operación

4 ANÁLISIS DE FALLOS
4.1

GENERAL

Instructions in case of any failure;
1.
2.
3.
Typical faults, to be solved by your contractor (supplier) are:
Typical faults
1
2
3
4
5
6
7
8
9
0089592_oi_compr_oa_spanish_~_4
17.10.2018
Advertencia
In case you find any problems in the installation, or one of the issues
mentioned in the inspection list are not OK, (temperatures, oil level,
pressures , ...), the compressor must be switched off. Your contractor
(supplier) should inform you how the compressor has to be stopped
safely. Refer also to the plant manual.
Advertencia
If crankcase is frosted or wet: stop compressor immediately.
Stop compressor
Make note of the information on the type plate of the compressor
Consult your contractor (supplier)
FAULTS
Discharge pressure too high
Discharge temperature too high
Suction pressure too high
Suction pressure too low
All cylinders inactive while compressor is operating
Too high oil consumption
Too high oil pressure during normal operation at working temperature
Too low lubricating oil pressure
Too low or no control oil pressure (dependant on compressor series)
ANÁLISIS DE FALLOS
GENERAL
15