Installing The Controller; Preparing The Case; Mounting The Controller; Wiring - SOMFY FX230 Manual De Instalación

All manuals and user guides at all-guides.com

INSTALLING THE CONTROLLER

Preparing the case

• Remove the cover
Important: Do not remove the electronic circuit board.
• Drill out the mounting holes taking care not to damage the circuit board.
• Use the controller case as the pattern for marking the mounting points on the gate post.
• Drill the gate post.
• Insert the cables and cut them to length.
The electric power line should:
• be reserved exclusively for use by the gate opener,
• have a minimum cross section of 1.5 mm
• be provided with a protection device (10A fuse or circuit breaker) and a residual current device (30 mA),
• be fitted with an omnipolar disconnection mechanism (refer to standard EN 60335-1),
• be installed in line with applicable safety standards.

Mounting the controller

Mount the FX230 on the gate post under the motor drive unit.

Wiring

GND

CONNECTING PERIPHERAL ACCESSORIES

Automatic blinking 230V orange light
Copyright © 2008 Somfy SAS. All rights reserved.
,
2
5