Troubleshooting; Meaning Of The Messages Displayed On-Screen; Removing The Controller - SOMFY FX230 Manual De Instalación

All manuals and user guides at all-guides.com

TROUBLESHOOTING

Meaning of the messages displayed on-screen

Before accessing the list of menus, the FX230 screen displays the following information:
• Somfy
• Product name
• FX230 software version level
• Number of cycles performed (a value expressed in hundreds). During the first 100 operations, the screen displays 0000.
If incorrect operation occurs, a message is displayed showing which mechanism should be checked. If the problem found
cannot be corrected, contact Somfy technical support.
The screen located on the electronic circuit board displays useful information during normal operation and when faults
occur.
The following messages indicate which mechanism to check:
Message Meaning
OK Learning successful
KO Learning failed
Awaiting a value or function
End Exit programming mode
SuC Closing limit stop enabled
SuO Opening limit stop enabled
AMP Obstacle detected
PED Pedestrian entrance function on
START START input on
STOP STOP input on
PHOT PHOT input on
CLOSE CLOSE input on
OPEN OPEN input on
SWO1 Motor 1 opening limit stop input on
SWC1 Motor 1 closing limit stop input on
SWO2 Motor 2 opening limit stop input on
SWC2 Motor 2 closing limit stop input on
TH Software thermal protection function triggered

REMOVING THE CONTROLLER

Warning: This operation must be performed by qualified personnel.
If the FX230 controller is to be removed and refitted elsewhere:
• cut the power supply and disconnect the entire electrical installation,
• if some components cannot be removed or are damaged, replace them
Copyright © 2008 Somfy SAS. All rights reserved.
Comments
Ensure that the peripheral that controls the pedestrian entrance is
operating properly.
Ensure that the peripheral that controls the START input is operating
properly.
Ensure that the peripheral that controls the STOP input is operating
properly.
Ensure that nothing is blocking out the photoelectric cells.
Ensure that the peripheral that controls the CLOSE input is operating
properly.
Ensure that the peripheral that controls the OPEN input is operating
properly.
Electro-magnetic detection system failure. Replace it.
Electro-magnetic detection system failure. Replace it.
Electro-magnetic detection system failure. Replace it.
Electro-magnetic detection system failure. Replace it.
Wait for this message to be cleared before continuing to use the motor
drive system.
13