ERMILA 4431 Instrucciones De Uso página 8

ENGLISH
· Disconnect from the mains before cleaning or servicing the appliance.
de
· Never use the appliance if it is defective, if it has fallen onto the floor or if the mains cable
is damaged. A damaged mains cable may only be replaced with an original replacement
en
cable by an authorised service centre or another similarly qualified person, in order to avoid
hazards.
fr · Repairs may only be performed at an authorised service centre using original parts. Only
specialists properly trained in the handling of electrotechnical appliances may repair electrical
equipment.
it
· Only use accessories recommended by the manufacturer.
· When disconnecting the appliance from the mains, never pull on the mains cable or on the
es
appliance itself.
· Do not hold the appliance by the mains cable to carry it and do not use the cable as a
pt
handle.
· Do not wind the mains cable around the appliance.
nl
· Keep the mains cable and appliance away from hot surfaces.
· Make sure that the mains cable is not twisted or kinked when used and stored.
sv
· Never use the appliance where aerosol (spray) products are being used or where oxygen is
being released.
· Do not expose the appliance to temperatures below 0°C or above +40°C for any length of
no
time. Avoid direct exposure to sunlight.
· The appliance is safety-insulated and radio-screened. It meets the requirements of EU
fi
Electromagnetic Compatibility Directive 2004/108/EC and Low Voltage Directive 2006/95/EC.
· We are not liable for damage caused as a result of improper use or failure to observe these
tr
operating instructions.
pl
Operation
· Unfold the base stand and place the appliance on a flat, smooth, non-heat-sensitive surface.
cs
· Connect to the mains power supply.
· To switch on the appliance, turn the temperature control dial right and set the desired tem-
perature (120° - 200°C) (Fig. 1ⓐ).
sk
· Red LED lights up.
· After approximately 5 minutes, the appliance will be ready for use.
hu
· Switch off the appliance after use (Fig. 1ⓑ). To do this, turn the temperature control dial left
until it clicks into position. The red LED must go out.
sl
· Disconnect from the mains power supply.
· Allow the appliance to cool down.
ro
CERAMIC coating
bg
Negative ions have an antistatic effect and are gentle to the hair. They close the scale layer,
creating a smooth, silky hair surface and lock in the natural moisture of the hair, thereby creat-
ing the ultimate shine.
ru
IONIC function
uk
The appliance's permanent IONIC function means that it is gentle on your hair, makes styling
easy and prevents static charging.
el
ar
8