Listening To Records - Roadstar TT-380BT-T Manual De Instrucciones

1 English
LOCATION OF CONTROLS
1. SPINDLE ADAPTOR
2. TRANSIT SCREW
3. 33/45/78 RPM SPEED SELECTOR
4. AUTOSTOP SWITCH
5. FUNCTION SELECTOR
6. BLUETOOTH LED
7. LINE OUT SOCKET
8. DC POWER SOCKET
POWER SUPPLY
Insert the DC plug, at the end of the AC/DC adaptor cord, into the DC
9V INPUT socket (8*) located on the back of the unit.
Connect the AC/DC adaptor into a 230V ~ 50 Hz AC power outlet.

LISTENING TO RECORDS

1. To prevent damages from transportation, a transit screw is located
at the upper right side of the turntable platform. Before start playing,
use a screwdriver and turn the transit screw in clockwise direction
(screw going down) completely. In case of transportation, remem-
ber to clock again this screw in counter-clockwise direction to pre-
vent damages.
2. Open the Record Player Cover. Release the Tonearm Clamp, and
remove the stylus protector. Place a record on the turntable, over
the central spindle. Place the EP adapter over the central spindle
when playing 17cm EP records.
3. Set 33/45/78 RPM SPEED SELECTOR (3) to 33 / 45 / 78 rpm ac-
cording to the record.
4. Lift the Tonearm with the Tonearm Lift Lever. Move the tonearm to
the beginning of the record, or to the start of a particular track.
Gently lower the tone arm onto the record with the Tonearm Lift le-
ver to start playing.
5. To select autostop mode, move AUTOSTOP SWITCH (4) to ON po-
sition. When the record is finished the tonearm will automatically
stop. To stop manually, lift the tonearm from the record and return it
to the rest.
6. Moving or jarring the turntable without securing the Tonearm clamp
could result in damage to the Tonearm. Replace the protective cap