dirna Bergstrom bycool green line DINAMIC 1.1 VOLVO FH Euro 6 Manual Del Usuario página 9

TO ACTIVATE REMOTE CONTROL
- With the unit off, keep the
the display. When it stops flashing, touch any control key for it to be recognised. The unit will
go off if no control key is pressed in 30 seconds. (Up to 5 controls can be programmed for a
single item of equipment).
TO DISABLE REMOTE CONTROL
- In order to delete any programmed control, keep the control panel
appears on the display, and then press the
C
until
All activated controls are automatically cancelled (do not wait more than 30 seconds between
pressing one key and the other or equipment will be switched off).
ca will appear on display. alternatively whith the selected temperature. If temperature is
above 32º inside vehicle, when equipment is switched on, blower and compressor go into
maximum power for about 20 minutes, then blower and compressor regulate their capacity
depending on inside temperature.
-
+ By pushing , one key or the other, desired temperature is chosen, between 15º and
27º C - 59-80º F
With this function, compressor goes into maximum power with minimum air speed.
Compressor is activated or desactivated according to temperature selected on display.
By maintaining +
display. Release on desired speed.
-
By maintaining
display. Release on desired speed.
-
+ By pushing only once, one key or the other, desired temperature is chosen, between
15º and 27º C - 59-80º F
-
key pressed down on the control panel until
F4 Automatic functioning
F0 Manual functioning
, pushed, blower speed increases and U1, U2, U3, U4, U5 appear on
, pushed, blower speed decreases and U1, U2, U3, U4, U5 appear on
key.
+
9
EN
®
flashes on
C
-
key pressed down