Assembly - Greencut GE8010E Manual De Instrucciones

54

ASSEMBLY

1. Slide the wheel (A) through the shaft and fix it by means of the corresponding screw and washer.
2. Attach the front support (B) with its corresponding screws and washers.
1
3. Mount the intake hopper (C) and the discharge hopper (D). You must fix the intake hopper by fitting
the upper hinges and by means of the two screws, nuts and lower washers. The same procedure must
be followed for the assembly of the discharge hopper (the orientation of the discharge hopper may vary
depending on the model).
4. Insert the carrying handle (E) into the front of the machine and tighten the screws making sure that it is
fastened correctly.
3
C
A
D
E
2
B
4