MINIMOKA CM-4758 Manual Del Usuario página 23

Note:
Remember that in two cup mode, two brewing operations
are implemented in sequence and correspondingly, if a
pot is selected for four/eight cup mode, 4 or 8 brewing
operations are implemented. Only remove the cups or
pot when all brewing operations are finished.
During coffee preparation, the coffee powder is moiste-
ned with a small amount of water first for pre-brewing.
The actual brewing process takes place after a short
pause.
You can stop coffee dispensing prematurely by briefly
pressing OK (button 6). In the case of strongly uneven
or only one-sided cup filling during 2-cup operation,
check whether one or both coffee dispensing spouts are
blocked on the inside by foreign bodies (coffee bean or
similar).
Changing and storing the cup filling level in bean
mode:
The coffee machine is set for standard quantities by
default. However, you can set the cup filling level indivi-
dually for each cup size. Proceed as follows:
- Press the button 4 repeatedly until the required cup
symbol for the desired ground coffee quantity is displa-
yed.
Note:
The cup filling level for one cup is stored during this
process. (Appliance must be set to one cup mode).
Place an appropriate cup under the coffee delivery spout
(Espresso cup, coffee cup or coffee mug).
Press key 5 repeatedly until the symbol for the required
coffee grinding quantity lights up.
Press OK (button 6) and keep it pressed until the desired
filling amount is reached.
Release the button. The new cup filling level is now
stored.
Note:
Repeat the procedure if you also wish to change the
filling level for the other cup sizes.
All values remain stored even when the coffee machine
is switched off. Should you change your cup size, you
can adapt the cup filling level individually at any time.
The stored cup filling levels for each individual cup sym-
bol only applies in bean mode.
Preparing coffee with powdered coffee:
-Select the "coffee powder " function by pressing the
button 5.
-The following symbol lights up in the display:
Note:
During preparation of coffee with powder, only one cup
can be prepared with powdered coffee.
The "ground coffee quantity" function is deactivated.
Therefore no information on the ground coffee quantity
appears on the display.
-Select the desired cup size by pressing the button 4.
The following selections are possible:
-Open the lid of the coffee bean container (M) and the
coffee powder shaft (J)
-Pour in the fresh coffee powder.
-Then close both lids again.
CAUTION:
Ensure that powder does not clog the container and that
no foreign matter gets into the container.
Never fill the container with more than one level measu-
ring spoon of coffee powder.
The filling container is not a storage container; the pow-
der must be transported directly to the brewing unit.
-Place a cup under the coffee dispensing spout.
-In order to reduce heat loss and splashing, adjust the
height of the dispenser to suit your cup size by moving it
up or down.