Publicidad
Idiomas disponibles
Idiomas disponibles
Note:
If the height adjuster is difficult to move, clean it.
Press OK (button 6) to dispense coffee.
Note:
You can stop coffee dispensing prematurely by briefly
pressing OK (button 6).
Changing and storing the cup filling level in powder
mode:
The coffee machine is set for standard quantities by
default. However, you can set the cup filling level indivi-
dually for each cup size. Proceed as follows:
- Select the "Coffee powder" function by pressing the
button 5.
-The following symbol lights up in the display:
Press the button 4 repeatedly until the required cup sym-
bol for the desired ground coffee quantity is displayed.
-Place an appropriate cup under the coffee delivery
spout (e.g. coffee mug).
-Fill the coffee powder shaft with fresh powdered coffee.
-Press OK (button 6) and keep it pressed until the desi-
red cup filling amount is reached.
-Release the button. The desired cup filling level is now
stored.
Note:
Repeat the procedure if you also wish to change the
filling level for the other cup sizes.
All values remain stored even when the coffee machine
is switched off. Should you change your cup size, you
can adapt the cup filling level individually at any time.
The stored cup filling levels for each individual cup sym-
bol only applies in powder mode.
Setting and storing the coffee temperature
-Switch to the menu function by simultaneously pressing
buttons 2 and 3 for approx. 3 seconds.
-The function displays of the menu will flash first in a
blinking line, then the current settings will be displayed.
-Then press key 4 repeatedly until the required hardness
coffee temperature is set.
-The image below shows the displays for the 3 possible
coffee temperature settings.
-Save the entries and quit the menu by confirming with
OK (button 6). All function displays of the menu flash for
approx. 3 seconds to confirm. The appliance then returns
to the normal operating mode.
Setting and storing shut-off time
- Switch to the menu function by simultaneously pressing
buttons 2 and 3 for approx. 3 seconds. The function
displays of the menu will flash first in a blinking line, then
the current settings will be displayed.
-Then press key 5 repeatedly until the required switch-off
time is set.
-The image below shows the displays for the 4 possible
switch-off times.
Publicidad
