Before Use; Baby Unit; Parental Unit; Connection Between The Two Units And Distance Of Use - Beaba SIMPLY ZEN Manual Del Usuario

III. BEFORE USE

1 - Baby Unit

1m
Plug the Baby Unit into the mains and place the Baby
Unit at least 1 metre from baby's head and up to 2.5
metres from baby for a good audio quality
The Baby Unit must remain plugged into the mains to
operate as it does not have a battery.

2 - Parental Unit

When the Parental Unit is switched on for the first time, it must be plugged into
the mains for 8 hours to recharge the supplied adapter (5V DC /0.55 A). If the
Parental Unit is already recharged, you can switch it on and use it directly without
plugging it in thanks to the Lithium battery which provides an autonomy of 15
hours.

Connection between the two units and distance of use

When the Parental Unit and the Baby Unit are switched on, the connection is
automatic and both units are immediately paired.
Range
50 m inside and 300 m outside - range inside depends on the thickness of the
walls
*adaptor only available for the EU version
IV. INSTALLATION AND CONFIGURATION OF THE BABY MONITOR
The Parental Unit and the Baby Unit are paired by default. If for any reason the
two units no longer communicate, it is possible to re-pair them by following the
steps below.
- Turn off the Parental Unit and the Baby Unit
- Press and hold the ON/OFF button on the Baby Unit, release when the green
light indicator flashes.
- Press and hold the ON/OFF button on the Parental Unit, release when the light
indicated on the Baby Unit stops flashing.
How to pair a second Parental Unit to a Baby Unit?
- Turn the Baby Unit off and the second Parental Unit off
- Press and hold the ON/OFF button on the Baby Unit, release when the green
light goes from flashing quickly to flashing slowly.
- Press and hold the ON/OFF button on the Parental Unit, release when the light
indicator on the Baby Units stops flashing.
16
V. PARENTAL UNIT MENU
Use of the PARENTAL UNIT function buttons
PUSH TO TALK : Press and hold
the button to talk to baby
Function Indicator :
• Green flash : CHARGING
• Red flash : LOW BATTERY
• Orange :
NIGHT MODE
Sound Level
Indicator
Volume +
ON/OFF
1. Long press to turn on/off power
2.Quick press to turn
on/off night light
3. Quick press 3 times to
set night mode
Volume -

Parental Unit functions

Night mode - 0 waves: once activated, it cuts all wave emissions
when the Baby Unit does not detect noise. In «night» mode the
signal loss alarm does not work. The night mode is activated when
the light indicator on the Parental Unit is orange
WALKIE-TALKIE FUNCTION: press and hold this button to
communicate with the Baby Unit. The Baby Unit volume can
be adjusted by using the +/- buttons while holding the talk back
button
17