Before Use; Baby Unit; Parent Unit; Connecting The Two Units And Distance Of Use - Beaba ZEN PREMIUM Instrucciones

A. Camera (Baby unit)
B. Receiver (Parent unit)
C. USB cables x 2
D. 5V DC / 1A mains adapters (one for the
parent unit, one for the child unit)
III. BEFORE USE
a Baby unit
Plug the baby unit (camera) into the mains placing it at least 1 metre from your baby's head and up
to 2.5 metres from baby in order to enjoy good picture quality. The baby unit must be plugged into
the mains to work since it does not have a battery.
b. Parent unit
If you are switching on the parent unit
for the rst time, it must rst be plugged
into the mains for 8 hours using the
adapter supplied (5V DC/1 A USB) to
charge it. If the parent unit is already
changed, you can switch it on and use it
without plugging it in and bene t from 8
hours of autonomy thanks to the Lithium
battery.
c. Connecting the two units and distance of use
When the Parent and Baby units are switched on, they connect automatically and the two units
are paired immediately. The connection light on the Parent unit is symbolised by the «network
signal» pictogram on the top left of the screen. When the Parent unit and the Baby unit are paired,
the signal strength indicator shows the maximum number of bars, namely 4. The connection is
established. Otherwise, the signal strength indicator does not show any bars and the message
«No Link» is displayed.
E. Screws
F. Support
G. Tilting accessory
H. Manual
I. Reset pin
21