Publicidad
Step
Step 14
Carefully turn your unit over onto its front edges. Lay the
å
BACKS (H) over your unit.
Fasten the BACKS (H) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the BOTTOMS (F).
NOTE: Perforations have been provided for access
å
through the BACKS. Carefully cut out the holes needed.
Turn the CORD CLIP (31P) into the hole in the TOP (E).
å
These holes must line up
over the BOTTOMS (F).
The edge of the BACK should be
even with the edge of the UPRIGHT.
www.sauder.com/services
These holes should
line up over the LEG.
Edge without holes
H
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
31P
Do not put NAILS
E
in these two holes.
418326
1N
NAIL
(30 used in this step)
Edge without holes
H
These holes should
line up over the LEG.
Page 19
Publicidad
