Publicidad
Step
Step 16
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (J) to the LEFT END (B) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a PULL (101K) to the DOOR (J). Use two SILVER
å
5/8" MACHINE SCREWS (15S).
See the next step for DOOR adjustments.
å
101K
SILVER 5/8" MACHINE SCREW
(2 used for the PULL)
www.sauder.com/services
B
J
15S
418326
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Mounting
screw
Hinge
Page 21
Publicidad
