YATO YT-82390 Manual Del Usuario página 17

GB
speed may cause the surface being milled to burn and leave permanent marks on it.
Tips for milling
During milling, the plunge router should be guided by a smooth motion at a uniform speed. The smoother the guiding motion, the
higher the milling quality.
Avoid hitting the workpiece with the milling cutter.
Allow the plunge router to reach the set speed and only then start milling.
If milling must be continued, enter the milling cutter into the track at a full rotational speed. This will prevent the milling cutter from
being jammed in the workpiece.
MAINTENANCE AND OVERHAUL
CAUTION! Before carrying out any adjustment, servicing or maintenance work, unplug the tool from the power outlet. Having
fi nished working with the workpiece/material, inspect the power tool for damage by visually inspecting the exterior and the body
and the handles. Check the power cord and its rubber gland, the action of the ON/OFF switch, the vents for clogging, the motor
brushes for sparking, the noise of the bearings and the drive transmission, and how the power tool starts and runs. During the
warranty period, the user is not allowed to disassemble the tool or replace any components or parts, as this will void the warranty
rights. Any irregularities found during overhaul or the operation signal the need for repair at a service centre. For this purpose,
contact the manufacturer. Having fi nished your work, clean the housing, the vents, all switches, all handles and guards with
compressed air (at 0.3 MPa maximum), a brush or a dry cloth. Do not use any chemicals or cleaners. Do not use sharp tools for
cleaning. Remove the circular saw and clean the inside of the guards, the fi xing of the circular saw, as well as the saw itself from
dust and other impurities generated during operation. Clean handles, knobs and other adjusting parts with a dry, clean cloth.
O R I G I N A L I N S T R U C T I O N S
17