Ryobi RY43154 Manual Del Operador página 21

 Balance your weight with both feet on solid
ground.
 Keep left arm with elbow locked in a "straight
arm" position to withstand any kickback force.
 Keep your body to the left of the chain line.
 Keep your thumb on underside of handlebar.
BASIC OPERATING/CUTTING
PROCEDURES
Practice cutting a few small logs using the following
technique to get the "feel" of using the saw before
you begin a major sawing operation.
 Take the proper stance in front of the wood with
the saw idling.
 Press the switch lock-out and squeeze the
switch trigger then release switch lock-out and
let the chain accelerate to full speed before
entering the cut.
 Begin cutting with the saw against the log.
 Keep the unit running the entire time you are
cutting, maintain a steady speed.
 Allow the chain to cut for you; exert only light
downward pressure. Forcing the cut could result
in damage to the bar, chain, or motor.
 Release the switch trigger as soon as the cut
is completed, allowing the chain to stop. If you
run the saw without a cutting load, unnecessary
wear can occur to the chain, bar, and unit.
 Do not put pressure on the saw at the end of
the cut.
WORK AREA PRECAUTIONS
See Figure 16.
 Cut only wood or materials made from wood;
no sheet metal, no plastics, no masonry, no
non-wood building materials.
 Never allow children to operate the saw. Allow
no person to use this chain saw who has not
read this operator's manual or received ade-
quate instructions for the safe and proper use
of this chain saw.
All manuals and user guides at all-guides.com
OPERATION
 Keep everyone – helpers, bystanders, children,
 Always cut with both feet on solid ground to
 Do not cut above chest height as a saw held
 Do not fell trees near electrical wires or build-
 Cut only when visibility and light are adequate
Page 21 — English
CHAIN
LINE
THUMB ON
UNDERSIDE OF
HANDLE BAR
and animals – a SAFE DISTANCE from the
cutting area. During felling operations, the safe
distance should be a least twice the height of the
largest trees in the felling area. During bucking
operations, keep a minimum distance of 15 feet
between workers.
prevent being pulled off balance.
higher is difficult to control against kickback
forces.
ings. Leave this operation for professionals.
for you to see clearly.
STRAIGHT ARM
Fig. 15
Fig. 16