Metra 95-HDIF2 Manual De Instrucciones página 4

1. With the fairing removed set the OE
and Saddle Tramp fairings next to each
other and swap one gauge at time. To
remove the gauges use a 5/16th wrench,
loosen (2) nuts and remove the gauge
from the front of the fairing and the OE
ABS ring from the rear of the fairing.
When reinstalling the OE gauges make
sure that ABS bracket is keyed properly
into the notch in the inside of the
HDIF2 fairing.
2. There are three speaker plate choices
included with the 95-HDIF2 inner
fairing. (2) 6.5", (2) 6"x9", and (2) blank
plates for custom speaker sizes.
(Figure A)
4
FAIRING PREPARATION
6.5"
6"x 9"
Blank
(Figure A)
3. Use (6) #8 x 3/8" Philip screws per plate
and secure the speaker plate to the
fairing. DO NOT OVER TIGHTEN (Figure B)
4. The aftermarket speakers may be
installed at this time or when the
fairing is installed on the bike. When
installing your speakers, you will use
the hardware that came with your
aftermarket speakers to secure them to
the fairing.
5. Using a 3/16" Allen wrench remove the
(4) bolts holding the OE radio to the
radio bracket. (Figure C)
Continued on the next page
(Figure B)
(Figure C)
|
386.257.1187 MetraOnline.com