Metra 95-HDIF2 Manual De Instrucciones página 6

1. Two people are recommended for the
installation of the aftermarket fairing.
One person to hold the fairing and the
other to feed the OE wiring harnesses
through the oval hole. Line up the
mounting holes to the bikes bolts and
hold in place.
2. While one person holds the fairing in
place the second person can slide the
radio bracket up into the radio opening
of the fairing. Using the OE nuts hand
tighten the bracket and fairing to the
frame mount. (Figure A)
3. Before tightening the nuts down check
fitment of the radio screen and make
any necessary adjustments. Once in
place, use the 1/2" wrench and tighten
down fully. (Figure B)
NOTE: If the outer fairing is not fitting to the inner fairing, you must check OE wiring to
confirm no harnesses are in the way. This is a common issue and wire management is
key to getting the outer fairing to match up with the 95-HDIF2 inner fairing.
6
FAIRING ASSEMBLY
(Figure A)
4. Saddle Tramp recommends the
BC-HDSWC-WR to retain the OE handle
bar controls and wire up the power for
the aftermarket radio. From the OEM
this connector will only have the front
speaker's wires. To connect your rear
speakers to the aftermarket radio you
will need BC-9711 harness.
5. Refer to the image of the OE harnessing
to make sure the OE harnesses are in the
best location. Tip: when reconnecting
the gauges the wires with orange tape
are the top gauges.
6. Using the (8) #6 x 1" Black stainless
screws mount the grille frame and
metal mesh to cover the speakers. These
screws are designed to sandwich the
speaker plate between the outside and
inside of the fairing for a secure and
tight fit. (Figure C)
7. Reassemble the outer fairing in reverse
order of disassembly to complete the
installation.
(Figure B)
(Figure C)
|
386.257.1187 MetraOnline.com