Presto 75710 Guia De Inicio Rapido página 2

Programming flow time delay:
- Disconnect the power supply or take off the battery.
- Wait for 10 s.
- Reconnect power.
- Immediately press the button 2 times*: water has to flow 2 times within 15 s after the
button has been pressed.
- At the end of this cycle, press the button, and count (till required flow
during handling.
- Press the button at the required flow time
Programming of automatic rinsing:
- Disconnect the power supply or take off the
- Wait for 10 s.
- Reconnect power.
- Immediately press the button 3 times*: water has to flow 3 times within 15 s after the
button has been pressed.
- At the end of this cycle, press the
last use (1 time for rinsing after 6h, 2 times for rinsing after 12h ... till 10 times for rinsing
after 2.5 days).
- Water flows as many of times programmed (by steps of
Programming duration of mandatory flow:
- Disconnect the power supply or take off the battery.
- Wait for 10 s.
- Reconnect power.
- Immediately press the button 4 times*: water has to flow 4 times within 15 s after the
button has been pressed.
- At the end of this cycle, press the button·
till 5 minutes).
- Water flows as many of times the button has been pressed and the programming is
registered.
Programming thermal-shock flow of 30 min:
- Disconnect the power supply or take off the
- Wait for 10 s.
- Reconnect power.
- Immediately press the button 5 time*: water has to flow 5 times within 15 s after the button
has been pressed.
- Water flows during 30 minutes.
*In 1-second intervals.
ROBINETTERIE FRANÇAISE
delay.
battery.
button· to increase the delay for automatic rinsing after
battery.
time). Water flows
6h).