Matrix R30 Manual De Instrucciones página 90

A Open HARDWARE FOR STEP 1.
1
B Carefully pull the CABLES (1) through the CONSOLE MAST (2)
using the LEAD WIRE (3) located inside the CONSOLE MAST
(2). Discard the lead wire.
C Attach the CONSOLE MAST (2) to MAIN FRAME (4) using 4
R30
BOLTS (A) and 4 SPRING WASHERS (B). Torque settings: 23.1
R50
Nm / 17 lb-ft.
Note: Be careful not to pinch any wires while
attaching the console mast.
Hardware For Step 1
Description Qty
A Bolt 4
B Spring Washer 4
90
3
B A
1
2
4
A Open HARDWARE FOR STEP 2.
2
B Slide TOP CAP REAR COVER (5) over CONSOLE MAST (2) and snap into place.
C Slide TOP CAP FRONT COVER (6) over CONSOLE MAST (2) and snap into place
D Attach HANDLEBARS (7) to CONSOLE MAST (2) using 2 BOLTS (C) and 2 SPRING
R30
WASHERS (B). Torque settings: 23.1 Nm / 17 lb-ft.
R50
Hardware For Step 2
Description R30
C Bolt 2
B Spring Washer 2
L Flat Washer 0
R50
Y Use outside holes for XUR console
Z Use inside holes for all other consoles
Y Z Y
7
C
B L
R50
6
6
4
7
2
5
B
C 6