Greentouch MR Heater 1092HI-09-109 Manual Del Usuario página 10

TROUBLESHOOTING
PROBLEM
Error E1 displayed on
control panel.
Error E2 displayed on
control panel.
Power cord gets warm
to the touch.
Remote control does
not work.
Remote control
signal is weak and only
works sometimes.
Fan motor continues
to blow after unit is
powered off.
POSSIBLE CAUSE CORRECTIVE ACTION
The overheat
sensor has been
engaged.
The thermostat
sensor is broken
or not working
correctly.
Normal operation.
Weak or failing
batteries.
Pressing the buttons
too quickly.
Using the remote
control too far away
or at an off angle.
Normal operation.
Unplug unit, wait 15-20 minutes, then the sensor will
reset itself. Plug the unit back in and turn on the
heater. If the problem persists, call customer service.
Note: The other functions will work normally excluding
the heater. Until the problem is solved, the error will
only appear/sound when the heater button is pressed.
Unplug unit, wait 15-20 minutes, then the sensor will
reset itself. Plug the unit back in and turn on the
heater. If the problem persists, call customer service.
Note: The other functions will work normally excluding
the heater. Until the problem is solved, the error will
only appear/sound when the heater button is pressed.
This is normal for a heater appliance as it requires
more current to operate. Check the connections of
the appliance cord and the outlet. Make sure the
plug and outlet frequently to determine if it is HOT;
if so, discontinue use of the appliance and consult
overheating outlet(s).
Replace with a new CR2025 lithium battery.
(See page 8 for more information.)
Press the buttons slowly and steadily to ensure the
transmitter recognizes the request.
Move closer to the insert; the remote control will only
work within a distance of 20 feet and 45 degrees to
either side from the front of the heater.
This is a standard feature; the blower runs for an
additional 20 seconds to cool off heater tubes.
10