Care And Maintenance - Greentouch MR Heater 1092HI-09-109 Manual Del Usuario

CARE AND MAINTENANCE

MAINTENANCE
• Make sure the unit is turned OFF, unplugged and the heating elements of heater are cool whenever
you are cleaning the heater.
Clean the pre-filter using a vacuum cleaner with a hose attachment. With the unit off and cool
•
to the touch hold the vacuum hose against the back panel. The vacuum should remove most
dust and debris from the mesh screen. For a more robust cleaning you can remove the
pre-filter. Remove the screw securing the pre-filter to the main body. Then tip it out and away
from the body. Use the vacuum with the hose attachment to clean both sides of the pre-filter
before re-installing it.（see Diagram 1 on page 9）
• Make sure the unit is level and secure when using, periodically check the underside of the base to
make sure is clean and level.
• When the heater is not in use, the heater should be stored in a dry location, away from possible
damage. The power cord should be stored properly to avoid contact with hot or sharp objects.
• Any other servicing should be performed by an authorized service representative.
STORAGE
• Make sure the unit is cool to the touch and all internal parts have cooled off before storing the product.
• The remote can be stored in the carrying handle
(See Diagram 2 on page 9).
• The cord can be wrapped around the base to shorten it for storage.(See Diagram 3 on page 9).
• Try to protect the unit from being tipped or dropped as it can damage the internal parts. If the unit has
been tipped or dropped take caution when using. Do a visual inspection, looking inside the unit for
any broken or loose parts. Gently tip the unit and listen for any loose parts. If all looks good take
caution while plugging the unit into the wall and when starting the unit to look, listen and smell for
anything out of the ordinary. If it sounds strange or smells of burning, immediately power off the unit
and unplug it from the outlet, then contact our customer service.
Replacing the Remote Control Battery
When the remote control (B) stops operating or its
range seems reduced, it is time to replace the
battery. Note: The battery should be removed if the
product is to be left unused for a long time.
1. The battery compartment is located on the back end
of the remote control (B).
2. Press the small tab inward as you slide the battery
door open and remove the old battery.
3. Insert a new CR2025 lithium battery (not included),
checking that the + and - sides of the battery match
the inside of the battery compartment.
4. Re-insert the battery door.
Disposal of Used Battery
A battery may contain hazardous substances that could be endangering to environment and
human health.
• This symbol marked on the battery and/or packaging indicates that used battery
shall not be treated as municipal waste. Instead it shall be left at the appropriate
collection point for recycling.
• By ensuring the used battery is disposed of correctly, you will help prevent
potential negative consequences for the environment and human health. The
recycling of materials will help to conserve natural resources.
For more information about collection and recycling of used batteries, please contact your local
municipality, your waste disposal service or the point of sale where you purchased this point.
locate at the top of unit on the back side
B
8