Greentouch MR Heater 1092HI-09-109 Manual Del Usuario página 7

OPERATING INSTRUCTIONS
TIMER ICON
• Press the TIMER ICON to set the countdown timer for the unit's main power.
• Note: The timer function requires the main power to be on.
• Press the TIMER ICON to scroll up through the timer settings which are:
30, 1H, 2H, 3H, 4H, 5H, 6H, 7H, 8H, 9H, OF. (30 means 30 minutes)
• The LED readout will display the timer setting for 10 seconds then will switch back to the
current room temperature.
• When the timer reaches the last minute the LED readout will automatically activate and show
the remaining time counting down in seconds. When the timer reaches zero it will turn OFF
the main power and will maintain the last temperature setting in memory.
AIRFLOW ICON
• Press the AIRFLOW ICON to adjust the fan speed, this only works without the heat as fan
only function.
• Press the AIRFLOW ICON to scroll up through the fan speeds which are:
F1, F2, F3 (F1 = Low, F2 = Medium, F3 = High)
Press the POWER ICON to turn off the fan, this will also power off the oscillation if that
function is activated.
• When the fan is running, you can press the HEATER ICON to resume the heat function at the
previous set temperature, the fan speed will automatically set to the highest setting. Then
press the AIRFLOW ICON the heat will turn off and the fan will switch speeds to the previous
setting.
OSCILLATION ICON
• Press the OSCILLATION ICON to turn on the oscillation function , press it again to turn it off.
• The oscillation function will work with both the heater and the air flow functions. Either of these
functions must be powered on before the oscillation function will work.
• The fan body will oscillate 90 degrees.
TIP-OVER SWITCH FUNCTION
When the heater suddenly push over for about 15 to 30 degree that the machine will
•
immediately shut down. Move back the tower heater to normal position and press the
POWER ICON , the unit will return normal.
MEMORY FUNCTION
• This unit has a memory function that allows you to turn off the main power and retain all the
other function settings (excluding the timer function).
• When the unit's main power is OFF, press the POWER ICON once on the control panel or on
the remote control to power the unit ON and "wakeup" the individual function to resume at last
setting. Press the individual function icons again to adjust them. When the unit is powered off
next it retain the new setting in memory.
• When the unit is powered ON the LED readout will show the last temperature setting if a
temperature setting was not saved.
• To reset the memory, unplug the unit from the wall for 5 seconds.
7