Sunstech STBTK150 Manual Del Usuario página 11

(3) Listening from USB in jack:
FM ANT
AUX
L R
LINE IN
DC 20V
USB
(4) Setting up bluetooth pairing:
Initial pairing:
1. Switch on the tower speaker. Press the SOURCE button and select Bluetooth
mode.
2. LED display Bluetooth icon "BT" will blink non-stop in searching for device.
3. When a device is found, it will show the name "STBTK150" If the device require
a password, enter "0000" to pair with the tower speaker.
Re-pairing:
4. Switch on the tower speaker. Press the SOURCE button and select Bluetooth
mode.
5. Bluetooth icon "BT" will blink 3 seconds and it is automatically finding the last
device it was paired with. When the device is found, it can play back directly.
6. If there is no device found, the Bluetooth icon "BT" will continue to blink non-
stop. Enter password to start with or press SOURCE button to select FM, AUX in or
LINE in.
(Bluetooth SET UP) NOTE:
1. If Tower has Bluetooth connected to a device, you can press and hold the
MUTE/PAIR button 3 seconds to exit this device in order to pair the device with
another Bluetooth device.
2. The maximum transmission between the Bluetooth speaker and a device is 10
meters or 32 feet.
3. Interference may occur during playback when using the Bluetooth function
near other wireless devices. If playback through Bluetooth is problematic, move
the Bluetooth speaker and the playback device to a different location, or use the
3.5mm audio cable jack instead of the Bluetooth function.
1. Insert the USB device to the USB port on the rear of
tower speaker.
2. Connect the tower speaker to the power as previous
procedures. The Standby indicator will turn on.
3. Press the POWER button on the tower speaker or
Remote Control to power on the tower speaker.
4. Press the SOURCE button on the unit repeatedly to turn
to USB mode.
5. Power on the connected external player and start
playback as usual.
6. Other operations are same as AUX IN mode.
10