Power Source; Battery Precautions - Sunstech STBTK150 Manual Del Usuario

POWER SOURCE

Insert the small plug from the supplied
AC/DC adapter to the DC in jack on the
unit. Insert the AC/DC adapter to DC in
jack on the unit.
BATTERIES INSTALLATION (REMOTE CONTROL)
To replace the button cell:
1. Push the tab, then slide out the
battery tray as the figure on the right.
2. Replace the old button cell by a new
CR 2025 button cell as the polarity
markings on the remote control.
3. Close the battery tray.

BATTERY PRECAUTIONS:

Follow these the size and type of battery specified.
1. Use only the size and type of battery specified.
2. Be sure the follow the correct polarity when installing the battery as indicated
in the battery compartment. A reversed battery may cause damage to the device.
3. If the battery in the device is consumed or the device is not to be used for a long
period of time, remove the batteries to prevent damage or injury from possible
battery leakage.
4. Do not try to recharge the battery not intended to be recharged; it can overheat
and rupture.
5. The batteries shall not be exposed to excessive heat such as sunshine, fire or the
like.
6. Clean the battery contacts and also those of the device prior the battery
installation.
7. Do not mix different types of batteries together (e.g. Alkaline and Carbon- zine)
or old batteries with fresh ones.
AC Outlet
7
FM ANT
AUX
L R
LINE IN
DC 20V
USB
AC/DC adapter
OPEN
PUSH