Step 8
å
Carefully turn your unit over onto its front edges. Unfold
the BACK (M) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (M).
Push on opposite corners of your unit if needed to make
it "square".
å
Using your hammer, fasten the BACK (M) to your unit
using the NAILS (12).
å
NOTE: Be sure to tap NAILS into the holes that line up
over the UPRIGHT (C).
å
Peel the backing off of each FELT DISC (20) and stick
them on the edge of the ENDS (A and B).
å
NOTE: Be sure the FELT DISCS are placed approximately
1/8" in from the front edge of the ENDS.
This arrow should
be pointing up.
Page 12
These holes must line up
over the UPRIGHT (C).
M
A
This FELT DISC should set in 1/8"
from the front edge of the ENDS.
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
www.sauder.com
Caution
12
NAIL
(36 used in this step)
This FELT DISC should set in 1/8"
from the front edge of the ENDS.
429430 / 168-0094-8
8
B
20