Viega Multiplex Trio 6170.10 Instrucciones De Montaje página 33

Instruction for use Multiplex Trio
GB
E
Assembly
o Push the sliding ring
and seal ring (on the
depression) on the drain
elbow. Screw the drain
elbow with the union nut
together with the odour
trap.
r Adjust the odour trap
and connect to the
wastewater system.
F
Assembly of the equipment set
 Set the valve cone
using the adjusting
screw and counter using
the union nut.
d Remove rotatable collar
and push it in as far as
it will go in the position
shown.
G
Setting the rise in the water level
 Presentation of
rotatable collar without
water level increasing
function.
d The water level
increasing function is
deactivated by pulling ①
or turning ② the
rotatable collar.
p Assembly with Viega
connection set:
Connect the water inlet
to the plug-in adapter.
s Check the drain fitting
for leaks after assembly.
 Remove red protective
foil. Insert valve cone.
Insert rotatable collar
(not all the way).
e Turn rotatable collar to
left, valve cone closed.
 The water level increase
is activated by pressing
the rotatable collar.
33
q Insert the plug-in
adaptor with mounted
water inlet into the
overflow fitting.
 Turn rotatable collar
to the left as far as it
will go. The valve cone
closes.
f Turn rotatable collar to
right, valve cone open.
 Presentation of rotatable
collar with water level
increase.