Publicidad
Idiomas disponibles
Idiomas disponibles
Digital protractor
Extra large LCD display
Display lighting
Audible signal when reaching
0 °, 10 °, 20 °, 30 °, 40 °, 50 °, 60 °, 70 °, 80 °, 90 °
Measured data can be stored.
Data is displayed horizontally in the display,
also for overhead measurement
Degree and percent conversion
Automatic shutdown
Low battery warning
Absolute and relative measurement.
Easy to use
3 devices in one: a protractor,
clinometer and spirit level
ON / OFF
Press this button for about 2 seconds to switch On or Off
))
Press )) and you hear a double beep. When it reaches 10 º, 20 º, 30 º, 40
º, 50 º, 60 º, 70 º and 80 º you hear a simple beep and reach 0 ° and 90 °
you hear a long interval beep.
Pressing the button )) terminates the function. When pressing the button
for about 4 seconds, the backlight is switched on. Backlight switched off
automatical after about 4 seconds.
0 / %
Press 0 / % you can change from degree to %, if press again you change
from % to degree.
Calibrate
Press button Calibrate to set the display to 0.00°, relative measurements
are possible. Press button Calibrate again returns to the absolute
measurement.
Hold
Press the HOLD button if you want to save the measured value.
The arrows on both sides of the display are flashing, press again to return
to the normal mode.
Digital protractor
Specifications:
Range: 4 side with 90 °
Accuracy: 0.1 °
Batteries: 3 x 3V CR2032
Operating temperature: 0°C ~ 40°C
max. Humidity: 40% ~ 80%
Dimensions: 150 x 50 x 8.5 mm
Backside
Art. 9330
Battery
Publicidad
