Publicidad
Idiomas disponibles
Idiomas disponibles
1. Adjust the width between a) and b) so that the tool fits into the door panel.
2. Push a cotter in between rubber seal and window. Now push the 'Wonder Tool' into the door
framing until its crown b) reaches the lower end of the window.
3. Carefully turn the tool towards the inner of the car but only until it just shows, looking from
outside. Then, pull it straight upwards so that crown and hook are located between Door panel
and window inside the car.
4. As soon as the hook reaches the upper end of the door panel, turn the tool towards the inner of
the car. Lower the door handle to open the door.
Vertical door handle: Hook the tool under the handle und pull it upwards.
Horizontal door handle: Direct the tip a) of the tool to the handle and pull forward.
Narrow and broad rail
Using these rails, you will be able to open almost all kinds of vehicles. While using the rails, it might
be helpful to bend them in different directions.
Plastic noose
1. Push the noose into the inner of the car through the rubber seal of the door.
2. Widen the outer strap and direct the noose over the door knob.
3. Tighten the noose around the door knob.
4. Pull the plastic noose upwards to open the door.
Filler cap key
Push the tool into the lock and move it back and forth until you can actually turn the key and unlock
the filler cap.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
Emergency Car Opening Set
6
e
s
s
a r t S
h
c
s
m
e
R
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
BGS 3541
L
d . l h
a t s
w
s
@
o f n i
: l i
Publicidad
