Ingersoll Rand 4151 Serie Instrucciones página 2

All manuals and user guides at all-guides.com
motion after throttle is released.
•
To avoid accidental starting - ensure tool is in
"off" position before applying air pressure,
avoid throttle when carrying, and release throt-
tle with loss of air.
•
Ensure work pieces are secure. Use clamps or
vises to hold work piece whenever possible.
•
Do not carry or drag the tool by the hose.
•
Do not use power tools when tired, or under the
influence of medication, drugs, or alcohol.
•
Never use a damaged or malfunctioning tool or
accessory.
•
Do not modify the tool, safety devices, or acces-
sories.
•
Do not use this tool for purposes other than
those recommended.
•
Use accessories recommended by Ingersoll-
Rand.
•
These Sanders will operate at the free speed
The use of other than genuine Ingersoll-Rand replacement parts may result in safety hazards, decreased tool
performance, and increased maintenance, and may invalidate all warranties.
Repairs should be made only by authorized trained personnel. Consult your nearest Ingersoll-Rand Authorized
Servicenter.
WARNING
This is the safety alert symbol.
It is used to alert you to potential
personal injury hazards. Obey all
safety messages that follow this
symbol to avoid possible injury
or death.
Ingersoll-Rand No. 68
Every 160 hours of tool operation, remove sanding
pad from spindle and inject 1 or 2 strokes of Inger-
soll-Rand No. 68 Grease through the end of the
spindle to lubricate the needle bearing in the
counter-balance.
USING THE TOOL (Continued)
•
•
NOTICE
WARNING SYMBOL IDENTIFICATION
WARNING
Always wear eye protection
when operating or performing
maintenance on this tool.
WARNING
Always wear hearing
protection when operating
this tool.
AGENCY SYMBOL IDENTIFICATION
European Community Mark
Indicates compliance with
relevant CE directives.
LUBRICATION
2
specified on the label if the air supply line fur-
nishes 90 psig (6.2 bar/620 kPa) air pressure at
the tool. Operation at higher air pressure will
result in excessive speed.
Use only a sanding pad, buffing wheel or polish-
ing bonnet with these tools. Do not use any
grinding wheel, bur or metal removing acces-
sory with these tools. Never use an accessory
having a maximum operating speed less than
the free speed of the Sander in which it is being
used.
When using a pad having a shank, insert the
shank to full depth in the collet. When using a
pad on a threaded arbor, make certain the
flange nut is tightened securely. Check the tight-
ness of the collet nut or flange nut before oper-
ating a Sander to make certain it will not loosen
during operation.
Read this manual before
operating tool.
(Dwg. TPA1751)
WARNING