Trouble Shooting - Dexter 20VIW2-350.1 Instrucciones Legales Y De Seguridad

7.TROUBLE SHOOTING

Problem Possible Causes
1. Battery Pack not properly
connected.
2. Battery Pack not properly
Tool will not start. charged.
3. Battery Pack burnt out.
4. Internal damage orwear. (Carbon
brushes or Trigger, for example.)
Tool operates slowly 1.Forcing tool to work too fast.
2. Battery Pack wearing out.
Performance Carbon brushes worn or damaged.
decreases over time.
Excessive noise or Internal damage or wear. (Carbon
rattling. brushes or bearings, for example.)
1. Forcing tool to work too fast.
Overheating. 2. Blocked motor housing vents.
Likely solutions
1. Remove Battery Pack, make
sure there are no obstructions,
reinsert the Battery
according to its shape (it should
only fit one way), and press firmly
until the Battery Pack locks in
place.
2. Make sure Charger is connected
and operating properly. Give
enough time for Battery Pack to
recharge properly.
3. Dispose of old Battery Pack
properly or recycle. Replace
Battery Pack.
4. Have technician service tool.
1. Allow tool to work at its own
rate.
2. Dispose of old Battery Pack
properly or recycle. Replace
Battery Pack.
Have qualified technician replace
brushes.
Have technician service tool.
1. Allow tool to work at its own
rate.
2. Wear ANSI-approved safety
goggles and NIOSH approved
dust mask/respirator
blowing dust out of motor using
compressed air.
FR
ES
PT
IT
Pack
EL
PL
RU
UA
KZ
RO
BR
EN
while
211