Attach The Cover Frame; Configuration Of System Software - Waeco CA-800-DAF Instrucciones De Instalación

CA-800-Install.book Seite 32 Mittwoch, 4. Juli 2007 3:05 15
Installation

6.2.7 Attach the cover frame

Tighten the screws carefully so that the cover frame is not damaged.
➤ Attach the cover frame (see fig. 5 on page 4, Pos. 5) with the four cy-
lindrical screws + washers M7 (see fig. 5 on page 4, Pos. 6) to the
system.
6.3

Configuration of system software

Before you first start up the system, adapt the controls according to the in-
stallation conditions. This must be done by the person installing the sys-
tem.
In configuration mode, the following system software parameters must be
set on the control panel (see fig. 10 on page 6):
Menu
level
1
2
3
4
The configuration mode can also be called if the undervoltage protection
has switched off the system and there is only residual voltage.
32
All manuals and user guides at all-guides.com
Parameter Meaning
Set temperature The system starts with the temper-
ature defined here.
Low-voltage The battery monitor switches the
cut-off system off at the defined voltage.
Operating mode The system starts with the operat-
ing mode defined here.
Default The parameters 1-3 can be
settings returned to the default settings.
CoolAir
Default
setting
20 °C
ID number
4 = 23.5
Volt
0 =
Automatic
mode
--