Cooper Crouse-Hinds EMP Manual De Instrucciones página 2

NOTE:
1. Mounting dimensions shown are based on devices assembled in an
enclosure with a 5/8 inch wall thickness and are aligned at a
specific depth for barrel protrusion through a 3/4 inch maximum
panel thickness. Dimensions will vary as enclosure wall and/or
panel thickness changes.
2. All devices are provided with a locking ring with one set screw for
locking from two directions on face of enclosure. An additional
clamping nut and locknut is provided for use on panel face.
3. All devices are 3/4-14 NPSM thread size.
IF 872 • 03/08
Figure 2
EMP Devices For Panel Mounting Applications
Copyright © 2008, Cooper Industries, Inc. Page 2