Cooper Crouse-Hinds EMP Manual De Instrucciones página 3

NOTE:
1. Mounting dimensions shown are recommended dimensions only
and may be varied. Inside depth of device will vary as enclosure
wall thickness changes (inside depths shown based on 5/8 inch
enclosure wall thickness).
2. Mushroom button protrusion dimension shown for EMP098
maintained stop pushbutton is minimum recommended and may be
varied to suit desired height.
3. All devices are 3/4-14 NPSM thread size.
4. All devices are provided with a locking ring with one set screw and
a locknut for locking from two directions on face of unit.
IF 872 • 03/08
Figure 3
EMP/EMPS Devices For Surface Mounting Applications
Copyright © 2008, Cooper Industries, Inc. Page 3