On/Off Switch - Black and Decker VH900 Manual Del Usuario

ENGLISH
Features

1. On/off switch

2. Container door
3. Release button for container door
4. Power cord retainer
Fig. A
5. Hard brush
6. Crevice tool
7. Rigid adaptor
8. Floor head
9. Hose
10. Blow adaptor
11. Tubes
12. Tool adaptor
13. Blow diffuser
14. Small inflator adaptor
15. Medium inflator adaptor
16. Large inflator adaptor
Assembly
Warning! Make sure that the appliance
is switched off and unplugged.
Fitting the accessories for
vacuuming (fig. B & C)
The accessories provided can be used in
various combinations, depending on the
task (fig. B):
a. General vacuuming / dusting
b. Vacuuming in confined spaces
c. Vacuuming stairs
d. Vacuuming upholstery
e. Vacuuming in corners
f. Vacuuming carpeted floors
g. Vacuuming hard floors
The hard brush (5) and the crevice tool (6)
are stored in the appliance. To fit an
accessory, proceed as follows (fig. C):
Take the accessories from the
x
appliance.
Insert the appropiate accessory into
x
the front of the appliance.
Fitting the accessories for blowing
and inflating (fig. D - G)
The accessories provided can be used in
various combinations, depending on the
task (fig. D):
a. Blowing
b. Inflating
6
To fit an accessory, proceed as follows
(fig. E & F):
Open the exhaust filter cover (17).
x
Insert the blow adaptor (10) into the
x
opening (18). Make sure the adaptor
fits snug against the rear of the
appliance.
Fit the hose (9) to the adaptor.
x
Insert the appropiate accessory into
x
the hose.
To fit an inflator adaptor to the hose,
proceed as follows (fig. G):
Align the tab (19) on the adaptor
x
with the hole (20) in the hose end.
Push the adaptor on the hose until it
x
clicks into place.
To remove the adaptor, lift up the
x
tab and pull the adaptor off the hose.
Use
Warning! Before connecting to the
power supply, make sure that the
appliance is switched off.
Warning! Never use the appliance
without the filters. Optimum dust
collection will only be achieved with
clean filters and an empty container.
Switching on and off (fig. A)
To switch the tool on, press the
x
on/off switch (1).
To switch the tool off, press the
x
on/off switch again.
Warning! Make sure the accessories
are securely attached before switching
on. Keep a firm grip on the appliance,
and especially the hose, when switching
on and during use.
Using the inflator adaptors (fig. H)
Choose the appropiate adaptor for
x
the item to be inflated.
During inflation, the airflow can be
x
adjusted by covering the hole (21)
with your thumb.
Do not over-inflate or exceed the
x
recommended pressure of the item
to be inflated.