Installing And Connecting The Batteries - Ghibli & Wirbel S2 Uso Y Mantenimiento

3.1.b - Installing and connecting the
batteries (Fig. 4)
WARNING:
Check that the recovery tank and the
clean water tank are empty.
- Disconnect the plug (1).
- Lift the tank (2) using the handle (3) until
completely turned over.
- Position the batteries (4) as shown in the
figure and connect them as shown on the
chart in Fig. 4 using the cables supplied.
- Tighten the terminals (5) using an insu-
lated wrench.
- Lower the tank (2).
- Connect the plug (1).
N.B.:
The battery must be connected by special-
ised personnel.
2
4
5
ENGLISH - 10
Professional Cleaning Machines Since 1968
1
3
S
S= Movement direction
www.ghibliwirbel.com
2
Fig. 4