Bosch PL1682 Instrucciones De Montaje página 10

BM 2609140681 10-09:BM 2609140681 10-09 10/23/09 1:42 PM Page 10
BEVELING EDGES
The V-grooves in the front planer base plate
allow quick and easy beveling of workpiece
edges.
Depending on required bevel width, use the
corresponding V-groove. For this, place the
planer with the V-groove onto the edge of the
workpiece and guide it along the edge (Fig. 9).
FIG. 9
DELUxE BEVEL GUIDE FENCE
The optional Deluxe Bevel Guide Fence
(Fig. 10) can be used to cut various desired
widths, with the additional capability of guiding
the planer on any angle up to 45 degrees to
allow edge chamfering (Fig. 9).
FIG. 10
9 mm
max
Installing the angle fence: Place the wing
knob through the appropriate hole in the guide
bracket and screw into the housing. Securely
tighten wing knob (Fig. 1).
All manuals and user guides at all-guides.com
Groove to be used
45°
Setting the cutting width: Loosen wing knob
and using the width scale, slide the fence
along the guide bracket to the desired position.
Securely tighten wing knob (Fig. 1).
Setting the cutting angle: Loosen round knobs
and pivot the fence to the desired position.
Securely tighten round knobs (Fig. 1).
Note that the adjustable front shoe contains
three chamfer V-grooves, which will follow the
corner of a workpiece to allow easier handling
when using the deluxe angle/width fence (Fig. 9).
The optional rabbeting depth stop accessory
(Fig. 1) allows the user to set any rabbeting
depth from 0 to 5/16" (9 mm). For best results,
it is important that the blade be properly
aligned (See "BLADE ALIGNMENT"). The
width of the rabbet is controlled by the width
fence. The final depth is achieved by repetitive
OPTION L
cutting until the rabbeting depth guide contacts
DELUXE GUIDE
the workpiece. The maximum rabbeting depth
is 5/16" (9 mm).
Setting the rabbet depth: Loosen wing knob
and using the depth scale on the rabbeting
depth stop, set the desired rabbet depth.
Securely tighten wing knob (Fig. 1).
-10-
Dimension a (mm)
None 0 – 4
Small 2 – 6
Medium 4 – 9
Large 6 – 10
RABBETING DEPTH STOP