Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Cod. 970073EIPb V04_21
In the case of the EXP8I/O they must have a jumper between the pins of JP7. If this expander already
has jumpers that configure the address, even if it is changed from the software, the address established
by the jumpers will remain the same. If you want to make the configuration from the software, you must
leave only the JP7 jumper to be able to enter in low level configuration and set the desired RS-485
address through the network.
11/30
Publicidad
Tabla de contenido
