Fermax AC-MAX CU-2KIT Manual De Instrucciones página 46

Cod. 970073EIPb V04_21
P S
OWER UPPLY
AC-MAX module requires to be supplied from 12Vdc.
RS485 B
US
Every module or device connected to the AC-MAX RS485 bus must have the unique address set in 100-
115 range. All power supply sources used to supply modules and devices connected to the same RS485
bus, must be connected by dedicated (separate) wire of any diameter and optionally, grounded in any
arbitrary selected point.
AC-MAX_CU E
Fig. 8 AC-MAX_CU board view.
Table 1: AC-MAX_CU Connection Terminals
Terminal Description
NC1 REL1/ NC contact
COM1 REL1/ COMMON contact
NO1 REL1/NO contact
NC2 REL2/NO contact
COM2 REL2/COMMON contact
NO2 REL2/NO contact
BAT+ x NO FUNCTION
BAT- x NO FUNCTION
AC x NO FUNCTION
AC x NO FUNCTION
AUX- 12Vdc/1A supply input, minus node
(EXP_VOUT-)
AUX+ 12Vdc/1A supply input, plus node
(EXP_VOUT+)
TML- 12Vdc/0.2A supply output, minus
node
TML+ 12Vdc/0.2A supply output, plus node A1
M
LECTRONIC
V
ODULE IEW
Terminal Description
IN5 IN5 input WG D0
IN6 IN6 input WG D1
GND Signal ground
IN7 IN7 input WG D0
IN8 IN8 input WG D1
GND Signal ground
OUT1 OUT1 transistor output
OUT2 OUT2 transistor output
OUT3 OUT3 transistor output
OUT4 OUT4 transistor output
OUT5 OUT5 transistor output
OUT6 OUT6 transistor output
GND Signal ground
RS485(1)/ Line A from EXP2D/EXP4D if
exist fingerprints readers.
EN
16/30