Fermax AC-MAX CU-2KIT Manual De Instrucciones página 47

Cod. 970073EIPb V04_21
IN1 IN1 input WG D0
IN2 IN2 input WG D1
GND Signal ground
IN3 IN3 input WG D0
IN4 IN4 input WG D1
GND Signal ground
Table 2: Power Supply LEDs
LED Function
AC Vac supply available
DC 12Vdc output available
Table 3: Status LEDs
Function in normal mode
LED1 Normal mode
LED2 None
LED3 Blinking: Low level configuration error
ON: High level configuration error
LED4 No memory card/ Memory card error
LED5 Event log error
LED6 License error
LED7 Not used
LED8 Blinking: Proper functioning in normal mode
Table 4: Technical Specification
Supply voltage
Backup battery
Current consumption
Inputs
Relay outputs
Transistor outputs
Power supply outputs
RS485 ports
Ethernet port
Wire lengths
Environmental class
(acc. to EN 50131-1)
Dimensions H x W x D
B1
CLK
DTA
GND
A2
B2
11.5Vdc-15Vdc, nominal 12Vdc,
13.8Vdc/7Ah, charging current 300mA
100 mA for 18Vac (no loads on AUX/TML)
Eight inputs, electrically biased to +12Vdc via 5.6kΩ resistor
Two relay outputs with single NO/NC contact 30Vac-dc/1.5A rated
Six open collector transistor outputs, 15Vdc/150mA rated. Max. total
current sink by all outputs up to 3A dc.
12Vdc/0.2A (TML)
Two RS485 communication ports
10BASE-T 10/100Mb communication port
1200m for RS485
150m for Wiegand and AC-MAX CLK/DTA
Class I, indoor general conditions, temperature: +5°C to +40°C, relative
humidity: 10 to 95% (no condensation)
72 x 175 x 30 mm
RS485(1)/ Line B from EXP2D/EXP4D if
exist fingerprints readers.
Transistor output
Transistor output
Signal ground
x NO FUNCTION
x NO FUNCTION
Function in service mode
None
Service mode
not used
Unknown error
IP address error
Memory card error
Not used
Blinking: Proper functioning in service mode
ON: Bootloader error
EN
17/30